This device has been specially designed to regulate rainwater use facilities and its design is consistent with the most advanced techniques. The device ensures the operation of the pump, charging valves and allows the control of the LED flasher as well as the level of filling and the general condition of the installation itself. If your installation is properly installed, this regulator allows you to operate without problems that saves you a lot of drinking water, while informing you in advance of possible pertubations in the system. As with the water level display, the water mark to which the drinking water recharge starts can be programmed. The recharging works virtually without hysteresis, so that there is only as much drinking water recharging as the supply pump took in the container. And that's how you and your installation even decide which brand the recharging should start. If you only supply the toilet flush or washing machine with rainwater, it will be enough for the refill to start at 6% above the dry walking protection. This device has a detailed testing program, which controls all entrances and exits as well as the display of water level and the supply of drinking water.
View LED fill level
Red LED: signals automatic recharging in drinking water.
Green LED: Shows the operation of the supply pump.
Power to the area and connection to the pump.
Connection cable (special cable, seable, but extension only following special instructions)
Pressure sensor (with results display)
Supply pump (possibility of installing a submerged pump)