Probe Nivind

This device has been specifically designed to address the facilities for the use of rainwater and its design corresponds to the more advanced techniques. The apparatus supports the operation of the pump, valves of rechargementet allows the control of the LED flashing and the level of filling and the General State of the installation it even.
If your installation is properly installed, this regulator will allows you to ensure a functioning without problems makes you save lots of drinking water, while informing you in advance of possible disturbances in the system.
As with the view of the water level, the water mark at which recharge water goes into road, may be programmed. Recharge works practically without hysteresis, so that there is only as much water recharge supply pump made in the container. And it is same and your installation and you decide what mark recharge must put on the road. If you load that hunting toilets or washing water of rain machine, it will suffice that recharge set en route to 6% above protection against running dry.
This device is equipped with a detailed test program, which control all entries and exits and the display of the level of the water and the drinking water supply.

1. Test/calibration button
2. The level of filling by LED display
3. Red LED: indicates the automatic recharge water.
4. Green LED: displays the operation of the pump of supply.
5. Food sector and connection to the pump.
6. Connection cable (cable special, scored, but extension only following special instructions)
7. Pressure (with display results)
8. Supply pump (possibility to install a submerged pump)
   
9. Valve reload.